A top with a scalloped front. No opening though, it slips over the head. Gathered sleeves.
Pattern drafted at course, based on my personal block.
Learned a lot. Still looking for a good arm hole + sleeve. This arm hole was cut 3 cm lower from the block. It’s about 1 cm too low at least. The sleeve should have been elongated at the underarm, I feel. Now it only allows for the arm to hang straight down.
Had to open the neck front more than initially drafted. I have a large head on a scrawny neck. The block is good for drafting tops with a wide neck or an opening (such as dress shirts) but it’s too tight when only regular drafting numbers are used for tops that slip over the head. Needs 5 cm more, on top of the regular numbers (1,5 cm at CF en CB here).
I feel the back has too much fabric lengthwise. The small of my back is not sufficiently accommodated. Yet my teacher showed that when arms are raised the back wil travel up. So fabric is needed. Perhaps additional shaping fixes the problem.
In the left front panel the bust dart is folded away: CF is not straight any more.
In the right front panel the bust dart is swivveled into a French dart. This one needs to have it end point about 5 cm lower, well below the apex. And at the side seam it needs to be lower too, about 10 cm.